Custom designed 3D Printed bobbin for the electric eel6. Bobbin is designed by Us!
This beautiful starburst pattern was inspired by a paper snowflake!
Bobbin shaft has a hole and a slit to attach your lead line to and all bobbins are tested before they go out.
Bobbins including bearings.
Gradient colors look best when printing more then one bobbin. Two plus look best for gradients. If you order only one bobbin, it may not go through all the colors.
This will fit the Electric Eel nano by dreaming robots.
3D Print Disclaimer: 3D Printing leaves subtle variations on the print including lines and fill. It can create variations in the color print as well. Gradients and rainbow prints cannot be guarantied on which color the gradient starts and finishes. Please don't leave them next to direct heat such as fireplaces, stoves or heating vents, Don't leave them in direct sunlight, don't submerge them in hot water and don't leave them under tension from your yarn. Please screw in bobbin ends gently and tighten until they stop, do not force the bobbin to over tighten or it may break the threads, they should fit snug. All of these things can effect the integrality of the product.
